Labi, gal kas pagelbesit...
Bandau va sita kontroleri:
Kompe viskas ok, reaguoja i valdyma ir t.t. Naturoj nepavyksta uzarminti. Vadovaujuosi situo "RTFM":
"Start / Winding engines:
Multirotor Place on a flat surface. Turn on the radio control before multirotor.
Connect the lipo without touching the multirotor during the time that board get
initializes (2 seconds is time required for the gyro and accelerometers are
calibrated).
Mount throttle stick to maximum position, then push the stick channel 4
(rudder) on the left, the green LED flashes once, then push the stick channel
4 (rudder) to the right, the green LED flashes again. Finally push down throttle
stick and push stick channel 4 (rudder) to right (the LED flashes once again),
the motors are armed.
Note: If you have activated the 'start with speed' engines are running in slow
motion.
Stop / unwinding engines:
Place throttle stick to minimum and push stick channel 4 to the left. Engines
are then disarmed.
Note: To get armed again you just push Throttle stick down and channel 4
right
If the engine stop accidentally disconnect and repeat the procedure, it is not
necessary to turn off the radio control"
Bet kaire svirtele keliant aukstyn ir i kaire zalias diodas nemirksi, stumiant i desine irgi nereaguoja... zodziu nemazai kombinaciju pribandziau- nulis reakcijos.
Gal kokia minti kas mestels tuo klausimu?
Prisijungti
Registruotis
DUK
Ieškoti
